The metal contact from your switch needs to be cleaned off, alcohol and a small brush or cotton swab will do it. You'll need to take off the door panel, unhook and remove the window switch module. Carefully pry off the top of the switch module. Be careful with the top, there's nothing holding them switches in! It's possible that in some of these cases, that the power window has been operated a few times without being closed fully, the AUTO function is disabled if the power window is operated for 10 consecutive times without being fully closed (turning the ignition OFF and then ON does not reset the counting), doing that, causes small errors in the window position sensor to accumulate and may 2014. Engine. Hemi 5.7. Will your passenger side window roll down with the passenger side switch? In any case you could check for possible DTC codes with the Alfa tool just to see if anything comes up but I would be leaning towards the switch or the door control module being the issue. The switch isn't expensive. For a better information on this as well as a possible fix, check on here. Apparently, following the Lexus forums, this is the preferred fix:" 1. Sit in the seat. 2. Open door that window is not working. 3. Hold the window button down. 4. The power window, side mirror - no power, the other windows work at each door with their own window switch, but not from the master switch. We have checked all the fuses related to the power windows behind the glove box and all are good. What should we check next to restore power to the window and mirror. Thanks! 4) Raise the driver's window all the way up without stopping by pulling the driver's switch to the second detent (auto up) when the window reaches the top, hold the driver's window switch in the auto UP position for 2 seconds. If the window does not work in AUTO, reset the power window control unit according to the above procedure again. In my lx470 the front passenger power window is not working in auto for up and down , (all other windows work in auto), if I stop pressing the switch the glass stop moving. I tried to push it in different ways and periods but not working, I tried to do programing by turning the switch to ON position and press window switch till half then move 7yFdmU.

power window switch not working